Skip to content
Tool

Pin planner

Choose your board and the parts in your project. The planner picks a pin for every wire, gives each I2C device its own address, and tells you where you need a level shifter, a divider or a pull-up, which pins can stop the board booting, and whether the board can power everything. It runs on datasheet-checked data for every part, not guesses.

1. Board

2. Parts

Add the parts in your project. You can add the same part twice, for example two BMP280s.

What the planner checks

  • Supply voltage. Each part goes on a rail it accepts, at its recommended voltage where it has one (an LCD2004 needs 5 V for contrast), otherwise at the board's logic voltage so its signals need no translation.
  • Signal levels. A 5 V output into a 3.3 V ESP32 pin, pull-up resistors to 5 V on an I2C backpack, a 3.3 V signal too weak for a 5 V input, or a 5 V Uno driving a 3.3 V-only chip: each gets a divider or the right level shifter.
  • Pin choice. No outputs on the ESP32's input-only pins, nothing on its flash pins or the USB serial pins, boot-strapping pins used last, and analog inputs kept on ADC1 so they still work with Wi-Fi on.
  • Buses. I2C parts share SDA and SCL and each gets a free address; a third BMP280 is flagged because only two addresses exist. SPI parts share the bus and each gets its own chip select.
  • Power budget. The maximum current of every part on a rail is added up and compared with what the rail can supply, such as the Uno's 50 mA 3.3 V pin.

Good to know

The planner covers the parts whose pages SolderHub has checked against their datasheets, and more are added as pages are verified. Modules vary between sellers, so confirm the result against the markings on your board, and follow the linked part guides for code.